7 Ways to Fix iPhone 11 Pro Max wont charge or turn on
Your iPhone 11 Pro Max wont turn on or charge correctly? There’s a number of reasons behind it such as the USB cable not functioning properly, the charging interface may be faulty or be loose, or even a software collapse.
In addition, it can be occurring due to third-party programs that may be interfering with the charging procedure or carrying an excessive amount of power due to that you can not observe again in the battery lifetime when you control the iPhone 11 Pro Max.
Another frequent issue due to that the iPhone 11 Pro Max wont turn on or charge isn’t upgrading the program. Always maintain your iPhone applications updated because outdated applications can slow down the charging procedure.
Not to worry, as the following tips will help pinpoint the rationale as to why the iPhone won’t charge or turn on and what you could do to fix it.
1- Clean the charging port of your iPhone 11 Pro Max
When lint accumulates in the charging port of your iPhone 11 Pro Max, it blocks the vent and causes certain mistakes in the relation between the phone and the charger along with the cable.
The perfect method to remove lint and dust out of this region would be to gently blow from the vent so the dirt is removed together with the sudden gush of air. Avoid using anything or strong to poke within the vent since you might wind up causing more harm to the vent than you planned.
2- Switch to a Different Cable/Adapter
Examine the cable for apparent damage, and when there is any possibility the cable is broken, then try out another one. Err on the side of caution keep in mind that a charging cable may have internal damage which is not visible or aren’t apple certified.
Also, try another power supply. It is convenient to control your iPhone 11 Pro Max with a USB port in your laptop, however, there are a whole lot of potential issues here — that the USB interface may have ignored, or it may not have the capacity to provide enough power to control the iPhone.
Rather, plug in the iPhone 11 Pro Max directly into the wall with an AC adapter to remove all the probable issues. If the socket is”changed,” make sure to put it on so power flows into the mobile phone.
3- Check the iPhone 11 Pro Max charging temperature
The lithium battery is quite sensitive to the overheating temperature. During charging large temperature may cause battery charging and degradation at temperatures over 45 °C will degrade battery performance, whereas in the lower temperatures that the inner resistance of the battery can increase, leading to quicker charging times.
4- Restart your iPhone 11 Pro Max
Press and keep holding the Sleep/Wake button towards the surface of the handset before the red slider looks onscreen. Slide it around to flip it off then replicate to flip the phone back.
When the iPhone is rooted and can not be resumed from the ordinary way do the following:
- Hard Reset
If your iPhone 11 Pro Max wont turns on, because of applications related issues, then doing a hard reset might help. Tough reset on iPhone, won’t eliminate user data however it simplifies RAM and finishes undesirable procedures.
5- Put iPhone 11 Pro Max in DFU mode
If nothing else works, you need to think about placing the iPhone in DFU mode. This will let you reset the unit to factory settings by connecting it to iTunes. It is a much more radical way than a recovery manner and needs to be tried as a last resort. The following steps will guide you;
- Hold the Power button and while holding it down, press the home button too.
- Keep pressing on the buttons for approximately 8 seconds and then release the power button and keep pressing the mouse button.
- Release the home button when the device enters DFU mode.
- Connect the iPhone to the laptop and when iTunes find the device in retrieval mode, click”OK” to restore the device
6- Reboot iPhone Without Data Loss
The issue with DFU mode and resetting your iPhone to factory settings is you will drop a few of the information on the apparatus. However, there’s yet another option if your iPhone wont turn on or charge, a third-party solution that may help you fix this problem without the chance of information loss. That solution is Tenorshare ReiBoot. To utilize ReiBoot, install it on your pc and follow these simple steps;
- Step 1: Launch ReiBoot in your own laptop and connect the iPhone 11 Pro Max into the pc using USB cables.
- 2: Just click “Download” to get the firmware package required to resolve the device.
- 3: When the download is finished, click “Start Repair” to start the repair procedure.
7- Still iPhone won’t charge or turn on? Contact Apple Support
If you have not tried the previous steps, you need to check to find out whether your own iPhone is still under guarantee with Apple. If that’s the case, and your problem is not due to water or hardware damage, take a look at the Apple Support web site – they may have the ability to correct the problem at no cost.
Leave a comment